Hello AKCP Team, We have read the details in your BattMon sensor manual and also the sensor datas...

Dear AKCP, We have sent an email to your support team (support@forum.akcp.com) but we have not re...

Hello AKCP Team, We were wondering if your AKCP E-sensor8 & E-opto16 expansion units are comp...

Hello AKCP, We have several devices for which we want to use SSL certificates, but we are unable ...

Hello AKCP, Can you please assist on the following questions? Can I use any type of external mode...

Hello AKCP, We are a bit confused regarding our SP+ devices, specifically the F4, F7, and H7 mode...

HAVE AKCP Dealer in thailand

Hello, I have 5 SP-WTS and related SP-WTs that I need to connect to the cloud. in the “serv...

Hello I have an application where a linear wire encoder is used to measure the sliding of an obje...

I have a SecurityProbe 5ESV-X60.  I have many of these in my network.  They all seem to only take...

I have two (2) SPX+ units and both show power; however, when I do a factory reset, it does nothin...

Hello, I’m trying to get informations about the Smoke sensor. I’ve already got temper...

What is the issue if my CCM results are negative?

I am trying to have another device listen for the MQTT data from an SP2+ rack temp setup.  I can ...

I bought a AKCP device and the device does not fully boot. Name: SensorProbe+ MAC: 00:0B:DC:01:90...

Hello, is it possible to retrofit SP8+ with X10 and internal GSM 1U rack mounted module with DIN ...

Hello AKCP, I have noticed a slight difference in the AKCP temperature readings displayed in my s...

Hello AKCP, I have noticed a slight difference in the AKCP temperature readings displayed in both...

Dear AKCP, Both my SP2+ and my SPX+ units are not showing the sensor graphs in my workspaces. Wha...

Hello AKCP Team, I have an SPX+ units with both the X10 dry contact modules. I want to know how f...